34
Ensure the cooker is cold before cleaning.
Removal of the oven door
To allow full access to the inside of
the oven for thorough cleaning, the
oven door can be removed.
Fully open the door and insert the
pins supplied into each hinge.
While closing the door to an angle of
about 30˚, lift and pull so that the
door leaves the mounting. Leave pins
in place.
Removal of the inner glass door panes
To assist with cleaning, the inner glass door panes are removable.
Open the door fully and insert the pins supplied into each hinge to secure the door in an
open position.
Locate the stainless steel clips at the base of the door.
Slide the clips towards the centre of the door.
Holding the glass, lift slightly and pull towards the oven; the glass pane will release.
The central glass pane is revealed. This can be cleaned in situ or removed.
To remove the central pane, remove the 4 screws and brackets.
It is important to remember when replacing the central pane that the rubber spacing
must be replaced first.
When replacing the inner pane, ensure the glass is print side up and the widest border is nearest the cooker.
It is not necessary to remove the door in order to clean the glass panes.
Oven interior
Delphi and Fleet models are fitted with stay clean liners as standard (oven sides only in 30cm and 40cm ovens).
To tell whether your oven has stay clean liners look at the oven walls. If the surface is grey in colour and rough in texture
then this is a stay clean liner. If the surface is smooth and black, this is an enamelled surface.
Fitting the stay clean liners
If you have purchased stay clean liners as an accessory, they are easy to fit.
Side liners
Remove all shelving from the oven.
Remove side shelf runners by pulling away using the centre of the bottom runner.
Place the holes in the side of the liner over the holes in the side of the oven.
Insert the side shelf runner into the holes starting with the top first, and then pushing in the bottom.
Back liners
(60cm and 90cm ovens only)
Place hole in centre, bottom of the liner over the hole below the fan at the back of the oven.
Screw into position.
Cleaning stay clean liners
We recommend that side shelf runners, telescopic runners and shelves are removed
prior to cleaning the stay clean liners and the door and floor are cleaned by hand.
After cooking (especially after roasting) remove all trays and shelves. Heat the oven to
maximum temperature for 15 – 20 minutes to allow the stains to catalyse (true fan or
fan assisted functions).
If the oven is heavily soiled, allow the oven to cool before cleaning the splashes with a
damp sponge. Then heat the oven for two hours at maximum temperature.
35
Cleaning your cooker
Cleaning your cooker
Repeat the cycle if difficult marks have not been removed.
Periodically, the side panels can be removed from the oven and washed with lukewarm soapy water before drying with a soft
cloth. Before refitting the panels, clean the enamel interior.
Enamelled surfaces
Do not allow vinegar, wine, coffee, milk, salt water or fruit juices to remain in contact with enamelled surfaces for prolonged
periods as they may stain or discolour the surface.
For light soiling wipe with a soft cloth, using warm water and washing up liquid. For heavier soiling use a cream cleaner and
a nylon scourer.
Oven cleaning products can be used according to the manufacturer's directions but care should be taken that they do not
come in contact with any stainless steel, chrome, coloured or alloy parts of the cooker or the door seals and elements.
A Britannia cleaning kit is available – please see the accessories section on page 36.
Side shelf runners, shelves, telescopic runners
If lightly soiled, wipe with a soft cloth, warm water and washing up liquid. For more stubborn marks soak in warm water and
washing up liquid and clean with a nylon scourer.
The side shelf runners and shelves can be cleaned in a dishwasher. (To remove these see page 34.) This is not advisable with
the telescopic runners as the detergent may remove the lubrication on the runners.
Removing & refitting the
telescopic runners
The telescopic runners fit any
shelf level, and work with both
the grill tray and wire shelves.
Locate the two spring clips at the
front and back of the runners.
Gently pull down the front spring clip.
Pull the runner away from the oven side – be careful not to strain the clip.
Repeat steps 2 – 3 on rear spring clip to remove runner.
To replace, hold runner level with front section of side support and clip in place. Repeat with rear section.
Removal of roof tray
The roof tray above the grill element can be removed for cleaning.
Support the grill element with one hand while removing the 2 wing nuts that hold the
element in place.
The element position will drop slightly allowing removal of the top liner.
Once cleaned and dried, the top liner can be
placed back into position, above the element,
and re-secured with the two wing nuts.
The liner will only fit into one position so
care must be taken to locate it on the rear
lugs and the front large lip must be facing
downwards.
Do not use the oven unless the liner is fitted and
the element has been re-secured with the wing
nuts.
Removal of the soft close drawer
Pull the drawer forward.
Locate the grey clips behind the runners at the front of the drawer.
Push in the clips and the drawer will release.
Replacing the soft close drawer
Replace the drawer on to runners and close.
WING NUTS
Содержание RANGE COOKERS
Страница 1: ...INSTRUCTION MANUAL RANGE COOKERS ...
