4
STEP 1
a. Attach wooden handle halves to metal brackets using 8-32 x
w
"
screws and nuts as illustrated.
b. Attach two handle assemblies to side of smoker body using
10-24 x
s
" screws and square nuts as illustrated.
c. Attach the three lower support brackets (V-clips) to inside of smoker
body through the three
4
" holes that are located about halfway down
the smoker body (lower level). Mount each bracket with notched side
facing up using 10-24 x
s
" screws and square nuts. Tighten screws
securely.
d. Attach the three upper support brackets (single clips) to inside of
smoker body through the three
4
" holes located near the top edge.
Mount each bracket with notched side facing up using 10-24 x
s
"
screws and square nuts. Tighten screws securely.
STEP 2
a. Attach hinge to inside of smoker body as illustrated. Use
6-32 x
4
" screws and nuts to attach hinge to smoker body.
NOTE: Attach the hinge so pin is facing out of smoker as illustrated.
b. Attach door to hinge using the remaining 6-32 x
4
" screws and nuts.
Pin Facing Out
Upper support bracket
with notched side
facing up.
Lower support bracket
(V-clip) with notched
side facing up.
7085-K_Gour Elec_Eng-SP.qxd 11/1/07 2:28 PM Page 6
