1
2
3
4
5
6
7
8
9
OPERATING THE GRIDDLE-PILOT LIGHTING INSTRUCTIONS
8
www.brikaequipment.ca
OPERATING INSTRUCTIONS
Before operating the griddle, it should be checked to see that it is sitting level. Adjust the feet to level the griddle. Be sure
the catch tray has been properly placed:
The pilot lights on the appliance have been set at the factory. Each burner has a pilot light.
Make sure all knobs are in the “OFF” position.
The main gas valve should be “CLOSED/OFF” for five minutes prior to
lighting pilots to clear any exiting gas. (Main gas valve is supplied by others.)
Turn “ON/OPEN” the main gas valve to the unit.
Light and hold an ignition source (match) at the pilots. When the flame is established, remove the ignition
source. Repeat this step for each burner as each burner has its own individual pilot. The pilot can be reached
through the holes in the front of the unit.
Adjust the pilot valve and make sure the pilot flame at 1/2 inch height.
Turn each burner knob “ON”. If the burners do not ignite promptly, turn the knobs “OFF”
From the opening in the front panel, use a screwdriver and turn the pilot valve screw counterclockwise which
will increase the flame height and repeat step 4.
The pilot flame should be as small as possible but large enough to guarantee reliable ignition of the burners
when the knobs are turned to “ON”. The holes located in the front panel are pilot valve adjustments. Use a
screwdriver to turn the valve to adjust the flame height to your desired level.
