21
Make the calibration once per 6months.
LUBRICATION
The only rotating parts of the wheel balancer are
the motor and the balancing shaft, so the bearing
of
these
components
must
be
checked
periodically by the operator and greased. If the
machine is used frequently (more than two hours
per day), check the bearing every year; if the
machine is not used so often, the check can be
made every two years. The bearing cannot be
opened for the test, so insert a screwdriver and
check the sound produced. As the bearing acts
as a clamping support, it is not easy to change or
take out the grease. In addition, the rotation
speed is not high for the machine, so it is not
necessary to change the grease. If you notice an
incorrect working or a noisy bearing, replace the
bearing. If the customer confirms that the bearing
has not been replaced, just change the grease,
then disassemble the bearing, open the dust
guard ring and add the grease (XHP103),
carrying out these operations under the guidance
of a professional. Calibrate the machine after
replacing the bearing. If the operation has not
been carried out correctly, the machine precision
will be affected, so reposition the dust guard ring,
reassemble the machine and repeat the
adjustment.
Technical safety card for using grease in the
wheel balancer
Mobilgrease XHP
103
NLGI degree
3
Type of thickener
Li-complex
Colour, appearance
Dark blue
Penetration
on
the
processed
item
25°,
ASTM D 217, mm/10
235
Dropping
point,
°C,
ASTM D 2265
280
Viscosity oil base, ASTM
D 445, cSt @ 40°C
100
Change of penetration
consistency, ASMT D
1831
10
(established upon the
rolling of the greases),
mm/10
4
spheres
test,
impression diam., ASTM
D 2266, mm
0.5
4 spheres test, welding
load, ASTM D 2509, kg
315
Test Timken OK load,
ASTM D 2509, lb
45
Stability of oxidisation
bomb method, ASTM D
942, pressure
drop at 100 hours, kPa
35
Corrosion
prevention,
ASTM D 1743
Passed
Emcor rust, IP 220, wash
away with acid water
0
Rust
protection,
IP
220-mod, wash away
with distilled water
0
Corrosion on copper,
ASTM D 4048
1A
Resistance
to
water
spray, ASTM D 4049, %
spray
15
Wash away with water,
ASMT D 1264, loss
(weight%), @ 79°C
5
SCRAPPING
If the machine is to be scrapped, separate all
electrical,
electronic,
plastic
and
ferrous
components and dispose of them separately, as
provided for by local regulations in force.
If the machines have the crossed-out bin symbol
on their data plate
, the following disposal
procedure must be applied to.
.
This product may contain substances that can be
hazardous to the environment and to human
health if it is not disposed of properly.
Содержание CB460 Series
