BRIGHT CB460 Series, Руководство пользователя

Страница: 12 / 28

9
using.
*Dynamic wheel balancer must use the separate
rated power source and connect with any other
electrical equipment to the socket. If without the
reliable earth power source, you must provide the
reliable power source.
* The input power cable must be firmly fixed.
* If you have to move the wheel balancer, you
must equip the protective device to avoid the
damage to the machine.
Installation area
*The distance between the rear of the wheel
balancer and the wall is more than 80cm and the
distance between the left panel and the wall
should be more than 50cm to secure the perfect
ventilation and the limit of space to the operation
and the distance between the right panel of the
case and the wall should be more than 200cm to
make it convenient to mount and demount the tire
and mount the lift device for the tire.
MOUNTING THREAD SHAFT
Before using the machine, you should mount the
thread shaft on the main shaft of the machine.
Before install the thread shaft, use the cotton yarn
to clean up the link between the main shaft and
thread shaft and then use spanner to firmly mount
the thread shaft on the main shaft by following the
figure.
*When the weight of the tire exceeds 15kg
，
you
should use the lift to carry the tire and not by hand
to avoid the injury to the person.
Before operating the wheel balancer, you must
use the anchor bolt to fix at 3points, or it will
produce the vibration to cause the inaccuracy of
the test result, especially the weight of the tire
exceed 35kg.
*The machine is equipped with protective hood
and the interlock switch. When the hood lower
the motor will automatically start up and the
motor will stop when raise the hood. Please do
not remove the hood foe your safety.
*The operator should wear the close-fitting work
suit, it is necessary to line up a good clothing
button or pull pouch hung from belt. The gloves
should be the thin gloves. When operation,
cannot wear the sandals and it is best to wear the
insulation shoe.
*When the machine in operation, there should not
be the other electronic equipments of the
≥50cm
≥80c
m
≥
200cm
FIG 5
FIG 6