BRIGHT CB460 Series, Руководство пользователя

Страница: 15 / 28

12
Mount the tire
Select the cone adapting to the center hole of the
tire and mount on the wheel balancer following
the indication of the figure.
Positive positioning is the normal method. It is
featured with simple and quick operation. It is
mainly suitable to the common steel rim and
aluminum alloy rim with small deformation.
Main shaft Wheel
（
direction of the rim
installation surface is inside
）
cone
quick nut
When the deformation of the outside of the wheel,
adopt this method to positioning to grantee the
accurate positioning of the steel rim inner hole
and main shaft. It is suitable to the steel rim,
especially the thick ALU rim.
Main shaft tower spring suitable
cone wheel bowl
quick nut
Suitable to the big tire assemble
Main shaft flange disk
（
fixed on the main
shaft
）
wheel cone quick
nut
Input the tire parameter
you can use the key to realize the unit conversion
from inch to mm.
After unit conversion, the unit of the display
values of rim Br and D are mm, but when you
switch off and then on the wheel balancer, the
unit will be still inch.
③
The unit conversion from gram to ounce
：
Normally, the unit of the unbalance
value is gram (g). If you want to make the
ounce(Oz) to be the unit, you can execute the
g/Oz conversion.
The unit of the displayed unbalance value is gram
（
g
）
. The way to realize the unit conversion from
gram to ounce is to press the key.
Press the start key
，
the wheel
balancer starts to run. A few seconds later, the
machine automatically stops. The machine can
also start by lowering down the protective cover
which can be set by the program. And the
FIG 13
FIG 10
FIG 11
FIG 12