7
or not.
•Remove the anchor bolt and detach the wheel
balancer but we cannot carry the mail shaft of
the wheel balancer.
•
If you have any question, do not use the
machine and contact with the supplier at
once.
Use of the wheel balancer
Transportation and installation
•Transport and move the machine in the direction
of the figure.
Note when handover the
machine
A
、
When transport the machine, be careful to
avoid the scratch and collide of the machine.
B
、
Carefully check if there are any damage or
fault in the process of transportation. Make the
problems be the report which will be sent to the
carrier and make mark and explanation on the
goods handover documents.
C
、
Check the construction of the machine and the
data on the nameplate of the product and the
motor is corresponding to the order. Timely
feedback if you have any question to adopt the
remedy ASAP.
D
、
Wiring and commission of the machine must
be done by the qualified person.
。
Wiring of the machine
A
、
Requirement of the circuit: Before wiring, you
must confirm the electrical parameters. The
power parameter from the user must comply with
the electrical parameter of the machine. When
use the machine, the user cannot directly connect
the power cable with the circuit and they should
specially equip a circuit breaker to avoid the
damage to the machine for the abnormal in the
circuit. Normally, we can choose the 15A dual
pole or tri-pole circuit breaker with the overload
protection and come off for the under-voltage. If
you want to use the large circuit breaker, you
should equip the additional fuses in the circuit.
The metal cross section of the lead should be not
less than 1.5mm and you can select 1.0mm2 for
the ground. If the environment is bad or frequent
access and exit of the equipments and persons,
the power cable should be buried underground or
in the air.
B
、
Requirement of the power source: Voltage of
the power source should be stable and the circuit
should have some overload capacity. The voltage
fluctuate should not exceed 10% of the rated
voltage and the frequency fluctuate will not
exceed 1Hz. Or you should add the voltage and
FIG 3
Содержание CB460 Series
