Briggs & Stratton Vanguard 10V300, Руководство по ремонту

Страница: 34 / 112

4
28
Starter Motor/Regulator (If Equipped)
1. Cut cable strap to release two regulator wire
connectors from starter solenoid housing.
2. See Figure 26. Disconnect two-place wire connector
( A ) between stator and regulator.
3. Remove hex nut ( B ), lock washer, and flat washer
from starter solenoid post.
4. If equipped with regulator red jumper wire, proceed
as follows:
A. Disconnect jumper wire connector (
C ) between
starter solenoid post and regulator.
B. Remove jumper wire ( D ) ring terminal from starter
solenoid post.
C. Remove extra length of jumper wire from behind
starter motor, if provided.
5. Remove two Phillips screws ( E ) to release regulator
from flywheel guard.
6. Remove key switch orange wire ring terminal ( F ) and
flat washer from starter solenoid post.
7. Disconnect key switch yellow wire terminal from
starter motor black/white wire terminal ( G ).
8. See Figure 27. Remove bottom starter motor screw
( H ) to release flywheel guard ( I ) and starter motor
from crankcase.
9. Remove bottom blower housing screw ( J ) to release
flywheel guard and blower housing from engine base.
10. Remove side blower housing screw ( K ) to release
flywheel guard.
26
27
28
11. If equipped, remove low oil sensor module as follows:
A. Disconnect one-place wire connector between oil
sensor and oil sensor module.
B. Disconnect one-place wire connector between oil
sensor module and armature.
C. Remove hex flange screw ( L ) to release oil
sensor module bracket from flywheel guard.
12. See Figure 28. Remove top starter motor screw ( M ).
13. Remove starter motor ( N ) from locating pins.
14. Remove locating pins ( O ) from crankcase.
Fuel Tank
1. See Figure 29. Remove two hex flange nuts ( A ) from
fuel tank studs.
2. On opposite side of fuel tank, remove hex flange
screw ( B ) to release fuel tank from crankcase flange.
Not for
Reproduction