Printed in USA © 2015
9
Document # 2102861 RevA
Brewer
FLEX
Access
Exam Table
Figure 14. Slide table off of pallet
INSTALLATION (continued)
15. Slide table partially off of pallet and stop when
there is sufficient room to place furniture dolly
beneath base of table. Finish pulling table onto
furniture dolly (Figure 14).
Leveling the Table
A leveling screw pad (Figure 15) is located in four
places under the table’s base. Adjust the four
leveling pads to achieve a solid, level installation.
Adjusting the Rear Base Extension
After leveling the table, the Rear Base Extension
should be brought into contact with the floor
(Figure 16).
1. Loosen the two Rear Base Extension adjusting
screws.
2. Lower plate until it contacts the floor.
3. Tighten the two Rear Base Extension adjusting
screws.
Figure 15. Leveling Screw Pad (located under table)
Turn out or in
to level
View of underside of base
Rear Base Support Plate
Rear Base Extension
Adjusting Screws
Figure 16 Adjusting the Rear Base Extension
Prevent Leveler Damage
Levelers must remain in the table, and be fully engaged a
minimum or (3) turns. If levelers are not fully engaged in the
base, damage to the threading in the base and/or leveler can
occur.
NOTICE
Prevent Floor Damage and Unwanted Table Movement
Make sure the rubber caps are present on all (4) levelers.
Missing caps can allow the table to slide, and the exposed
metal portion of the leveler can damage flooring.
NOTICE