Bresser TemeoTrend AI, Инструкция по эксплуатации

Страница: 14 / 36

14
Press the DOWN button again to get back to RC time mode. In Germany just select value ‘0’ to set
the time zone.
Alarm setting
1. Press the SET button once or several times to display one of the two alternative wake up times.
Once a mode is selected hold the SET button for 2 seconds to get into alarm setting mode.
2. The figure to be set will start flashing.
3. Press the DOWN or UP button to change this setting.
4. Press the SET button to confirm and go to the next setting.
5. The setting order is hour >> minute >> save and exit.
6. Press ALARM again to confirm and exit setting mode.
7. Press the UP button to turn on or off alarm A1, A2, or both. When the alarm is activated, the icon
is showed on the screen. When this alarm bell symbol is not displayed the alarm is off.
8. The alarm sounds for a total of 2 minutes and will change characteristics along that time.
Snooze function
1. When alarm is ringing, you can press the SNOOZE button to silence it for 5 minutes. The icon
will now flash as well.
2. Press any other button to turn off the alarm. The alarm will activate again after 24 hours at the set
time.
Sensor function
1. Move the CH switch to the position (1-3) that corresponds with the channel which will be used for
transmission (select channel 1 if only one remote sensor is connected). If you would like to connect
more than one remote sensor with the main unit, different channels need to be selected for each
sensor.
2. Press °C/°F to change the temperature display of the transmitter
3. Once the weather station receives radio signals from the sensors, the alternating temperature
values of the different channels will be updated on the weather station every 1-2 minutes.
TROUBLESHOOTING
Signal disconnection
If without obvious reasons the display of the outdoor temperature goes blank, please check the
following:
1. The remote unit is still in place.
2. The batteries of both the remote unit and main unit are not empty. Replace batteries with new ones
if necessary.
Note: When the temperature falls below freezing point, the batteries of outdoor units will freeze,
lowering their voltage supply, effective range, and life span.
3. All units required are within range and the path is clear of obstacles and interference. Shorten the
distance if necessary.
Transmission collision
Signals from other household devices, such as door bells, home security systems and entry controls,
may interfere with those of this product and cause temporarily reception failure. This is normal
and does not affect the general performance of the product. The transmission and reception of
temperature readings will resume once the interference recedes.
SPECIFICATIONS
Measurement
Indoor temperature range: 0~50° C
Outdoor Temperature Range: -20~60° C