Bresser TemeoTrend AI, Инструкция по эксплуатации

Страница: 12 / 36

12
Low battery warning
When batteries need to be replaced the respective low battery indicator will be shown near the
indoor temperature display (batteries for main unit) or near to the outdoor temperature (batteries for
remote sensor).
USING TABLE STAND OR WALL MOUNTING
The main unit has a removable table stand, which - when connected - can support the unit on a flat
surface. It is possible to remove the stand and mount the unit on a wall using the recessed screw hole.
The same applies to the remote unit; it can be placed on a flat surface or mounted on a wall using the
recessed screw hole.
OPERATION
Receiving measurements and time signal
Once batteries are placed in the remote unit, it will start transmitting temperature readings at roughly
45 second intervals. As soon as batteries are installed in the main unit it will start searching for a signal
from the remote sensor for about 3 minutes. Upon successful reception of the signal, the outdoor
temperature will be displayed on the main unit. The main unit will automatically update its readings at
about 45 second intervals.
Subsequently, the main unit will attempt to receive the DCF77 radio signal. The reception symbol flashes.
When the time signal is received after 3-5 minutes, the current time and date appear in the display. The
reception symbol will now be shown permanently in the display. Date and time are automatically updated
daily at 2:05 o’clock (CET) by the main unit.
Temperature and humidity
1. Press and hold the MAX/MIN button for 2 seconds to switch the display between °C and °F.
2. Once the battery is installed, the main unit will start displaying the interior measurement information.
The main unit will display the information from the remote sensor for the first time approximately 3
minutes after the power supply was established.
Max/Min records of temperature and humidity
1. Pressing and releasing the MAX/MIN button in short intervals repeatedly makes the display alternate
between the current temperature and humidity as well as MIN/MAX recordings.
2. The MIN/MAX temperature and humidity values will be recorded automatically.
3. The MIN/MAX temperature and humidity records automatically will be reset at 0:00 o’clock (12:00
a.m.) every day.
Current weather and weather trend
The weather forecast is depending on the fluctuation of temperature and humidity. From these values
a weather forecast for the next 6 hours is calculated.
Current weather Temperature, humidity and weather trend
Sunny
Partly cloudy
Cloudy
Rainy
Rising
Steady
Falling
Air pressure
The values for air pressure will be updated each hour and will be displayed as a numerical value between