Bresser 7802541, Инструкция по эксплуатации

Страница: 11 / 76

11
GB
2. Apply 4 rubber pads on the inner sides of the mounting
base and clamp of the 7-in-1 sensor, and loosely fasten
them together.
3. Place the 7-in-1 sensor over the mounting pole and align it
to North direction before fastening the screws.
MOUNTING POLE AND DIRECTION ALIGNMENT
Install the wireless 7-IN-1 sensor in an
open location with no obstructions above
and around the sensor for accurate rain
and wind measurement. Install the sensor
with the smaller end facing the North to
properly orient the wind direction vane.
Secure the mounting stand and bracket
(included) to a post or pole, and allow
minimum 1.5m off the ground.
Point to
NORTH
1.5 meter
off the
ground
Fixed pole
package not
included
INSTALL WIRELESS INDOOR SENSOR
1. Remove the battery door of the sensor.
2. Use the channel slide switch to set the channel number for the
sensor (e.g. Channel 1)
3. Insert 2 x AA size batteries into the battery compartment and
close the battery door according to the polarity information
marked on the battery compartment.
4. The sensor is in synchronization mode, and can be registered
to the console within the next few minutes. The transmission
status LED will begin to flash every 1 minute.