Bresser 7802541, Инструкция по эксплуатации

Страница: 13 / 76

13
GB
RESET AND FACTORY HARD RESET
To reset the console and start again, press the
[ RESET ] key once
To hard reset the console and resume factory settings, press and hold the
[ RESET ] key for
6 seconds
RESYNCHRONIZE SENSORS
Press the [ SENSOR / WI-FI ] key once for the console to enter sensor Synchronization
mode, and the console will re-register all the sensors that have already been registered to
the it before. i.e. the console will not lose the connection of the sensors that you’d paired
up before.
CHANGING BATTERIES AND MANUAL PAIRING OF SENSOR
Whenever you changed the batteries of the wireless indoor or 7-in-1 weather sensor, re-
synchronization must be done manually.
1. Change all the batteries to new ones in the sensor.
2.
Press [ SENSOR / WI-FI ]
key on the console to enter sensor synchronization mode.
3.
Press [ RESET ]
key on the wireless indoor or 7-in-1 weather sensor.
SYNCHRONIZING ADDITIONAL WIRELESS SENSOR(S) (OPTIONAL)
The console can support up to 7 additional wireless sensors.
1.
Press the [ SENSOR / WI-FI ]
key once on the console to enter synchronization mode.
2.
Press the [ RESET ]
key on the new sensor, and wait for a few minutes for the new
sensor to paired to the console.
NOTE:
- Channel number of the indoor sensor must not be duplicated among the sensors.
Please refer to “INSTALL WIRELESS INDOOR SENSOR” for details
- This console can support different type of additional wireless sensor, e.g. soil moisture
and pool sensor. If you would like to pair up additional sensors, please check with your
retailer for more detail.
POINTING THE WIRELESS 7-IN-1 SENSOR TO SOUTH
The outdoor 7-IN-1 sensor is calibrated to point to North for the maximum accuracy.
However, for the user's convenience (e.g. users in the Southern hemisphere), it is possible
to use the sensor with the wind vane pointing to South.
1. Install the 7-IN-1 wireless sensor with its wind meter end pointing to South. (Please
refer to
INSTALLATION OF THE WIRELESS SENSOR
section for mounting details)
2. Select "S' in hemisphere section of the setup UI setup page. (Please refer to
SETUP
THE WEATHER SERVER CONNECTION
section for setup details)
3.
Press
Apply
icon to confirm and exit.
NOTE:
Changing the hemisphere setting will automatically switch the direction of the moon
phase on the display.
CREATE WEATHER SERVER ACCOUNT & SETUP WI-FI CONNECTION
The console can upload weather data to WUnderground and / or Weathercloud through
WI-FI router, you can follow the step below to setup your device.
NOTE:
The Weather Underground and Weathercloud website are subjected to change without notice.