Bresser 7802541, Инструкция по эксплуатации

Страница: 23 / 76

23
GB
NOTE:
Once the ice pre-alert activates, the pre-set alarm will sound and ice-alert icon will flash 30
minutes earlier if the outdoor temperature is below -3°C.
When clock reach the alarm time, alarm sound will start.
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate
again in the next day.
- By pressing [ALARM / SNOOZE]
key to enter snooze that the alarm will sound again after
5 minutes.
- By pressing and hold [ALARM / SNOOZE] key for 2 seconds to stop the alarm and will
activate again in the next day
- By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next
day.
NOTE:
- The snooze could be used continuously in 24 hours.
- During the snooze, the alarm icon “ ” will keep flashing.
TEMPERATURE / HUMIDITY FUNCTION
- The temperature and humidity reading are display on the outdoor and indoor (CH)
section.
- Use the [ °C / °F ] slide switch to select the temperature display unit.
- If temperature / humidity is below the measurement range, the reading will show “Lo”. If
temperature / humidity is above the measurement range, the reading will show “HI”.
COMFORT INDICATION
The comfort indication is a pictorial indication
based on indoor air temperature and humidity
in an attempt to determine comfort level.
Too cold Comfortable Too hot
NOTE:
- Comfort indication can vary under the same temperature, depending on the humidity.
- There is no comfort indication when temperature is below 0°C (32°F) or over 60°C
(140°F).
WIRELESS SENSOR SIGNAL RECEIVING
1. The console display signal strength for the wireless sensor(s), as per table below:
Outdoor 7-in-1 sensor
Indoor channel sensor
No signal
Weak signal Good signal
2. If the signal has discontinued and does not recover within 15 minutes, the signal icon
will disappear. The temperature and humidity will display “Er” for the corresponding
channel.
3. If the signal does not recover within 48 hours, the “Er” display will become permanent.
You need to replace the batteries and then press
[ SENSOR / WI-FI]
key to pair up the
sensor again.