Breckwell Big E SP1000PB, Руководство пользователя

Страница: 17 / 27

CLEANING
a.
Heat Exchange Tubes – Your Breckwell Big E stove is
designed with a built-in heat exchange tube cleaner. This
should be used every two or three days to remove
accumulated ash on the tubes, which reduces the efficiency of
your unit. Insert the handle end (with hole) of the cleaning tool
onto the cleaning rod (refer to figure 15). The cleaner rod is
located in the grill above the stove door. Move the cleaner rod
back and forth several times to clean the heat exchanger
tubes. When finished be sure to leave tube cleaner at the rear
of the stove.
b. Interior Chambers – The two ash doors in the firebox in the
Breckwell Big E can be removed for periodic cleaning (refer to
figure 18). These doors allow access to the chamber behind
the firebox.
Periodically, you must vacuum ashes from this chamber. In
some cases you will need to remove creosote, which can
accumulate rapidly under certain conditions. A small wire brush
can be used. It is important to remove this creosote because it
is highly combustible. INSPECT BEHIND THESE CLEANING
PLATES AT LEAST ONCE PER TON OF PELLETS BURNED
UNTIL YOU ARE FAMILIAR WITH HOW ASHES AND
CREOSOTE ACCUMULATE WITH YOUR OPERATING
PRACTICES. Use the small wire brush to also clean the inside
of the chamber walls, above the access doors.
BLOWERS
DANGER: RISK OF ELECTRIC SHOCK. DISCONNECT POWER
BEFORE SERVICING UNIT.
Cleaning - Over a period of time, ashes or dust may collect on the
blades of both the combustion blower and convection blower.
Periodically the blowers should be vacuumed clean as these
ashes can impede performance. Creosote can also accumulate in
the combustion blower. This needs to be brushed clean. The
convection blower is accessed by removing the stove’s left side
panel. The combustion blower can be accessed by removing the
right side panel. The convection blower is on the left (facing
stove), and the combustion blower is on the right.
NOTE: When cleaning, be careful not to dislodge balancing clip on
convection blower or to bend fan blades. Some stove owners lightly
spray an anti-creosote chemical on the fire to help reduce creosote
formation within the stove.
FIGURE 18
MAINTENANCE 17
FIGURE 19
FIGURE 20
Air Switch Tube
Pellet
Hopper
Auger
Shaft
(A-AUG-22)
Combustion
Blower
(A-E-027)
POF
Thermodisk
(C-E-090-22C)
Air Inlet
Tube
Air Switch
(C-E-200)
High Temp
Thermodisk
(C-E-090-21)
Convection
Blower
(A-E-033)
Combustion
Blower
(A-E-027)
Auger Motor
(C-E-017)