Brecknell SBI-240, Руководство по обслуживанию

Страница: 22 / 78

20 SB
I-240
Service Manual
9. After an acceptable range has been set, check weighing may begin.
If the weighed value is within the specified range,
OK
will be displayed
on the indicator and an audible beep will sound.
If the value is outside the specified range,
HI
or
LO
will be displayed
with no audible beep.
10. To turn check weighing off, follow the above instructions and change the upper
limit to zero.
3.6 Accumulation Mode
The accumulation function allows storage of weighed values and the sums those
values. This function can accumulate weights, piece counts, and percentages in
normal weighing mode, counting mode, and percent weighing mode.
1. With a load on the scale, press the ACC/TOTAL key to add the displayed value
to the accumulated total.
The indicator will first display the number of accumulations (e.g. if this is
the 5th accumulated value, it will display
ACC.005
).
The accumulated sum total thus far will be displayed and then the load
weight will be displayed.
2. Remove the load and place another load to continue accumulating
3. Press and release the ACC/TOTAL key to add the new value.
NOTE: If the upper limit is 0, or if it is less than the lower limit, check weighing mode
will automatically be exited.
NOTE: Only loads exceeding the minimum weight (default of 10d, where d = the
scale's readability, see specifications) can be accumulated. This setting (
USER-
OTHER-NLD.RNG
) can be modified from its default within User Setup mode, but
changes will impact other functions such as HOLD.
NOTE: To avoid duplicating a value for a same load, the accumulation function
requires the original load to be removed before a new value can be accumulated.