BRAYER BR3020BL, Инструкция по эксплуатации

Страница: 6 / 32

6 EN
• Wipe the unit with a clean, slightly damp cloth
to remove dust, and then wipe it dry.
• Unwind the power cord to its full length while using
the unit.
USING THE HAIRDRYER
• Make sure that the operation mode switch (1) is set
to the position «0».
• Unwind the power cord completely.
• Insert the power plug into the mains socket.
• Use the switch (1) to set the required operation
mode:
- «0» – the hairdryer is off;
- «1» – warm air supply;
- «2» – hot air supply.
• The button (2) is the cool shot function, press
and hold down the «cool» shot button for fixing your
hairstyle.
Note: during the first operation a foreign smell and
a small amount of smoke can appear from the heating
element, this is normal and it is not covered by
warranty.
• After finishing operation, switch the hairdryer
off by setting the switch (1) to the position «0»,
and unplug it.
Nozzle
Use the nozzle (3) when you need to focus the power of
drying on a small area (for example, a curl
or a wave) or when you want to straighten wavy hair.
• Attach the nozzle (3) to the unit body. The nozzle (3)
allows directing a narrow air flow of high intensity
at a definite hair lock.
• Insert the power plug into the mains socket. Use the
switch (1) to set the necessary operation mode.
• When the desired effect is achieved, press the cool
shot button (3) and fix your hairstyle.
• Periodically straighten the power cord if it gets
twisted during operation.
Overheating protection
The overheating protection system switches the
hairdryer off if the outgoing air temperature is above
the limit.
If the hairdryer is switched off during operation, set the
switch (1) to the position «0», unplug the unit and make
sure that the air inlets and outlets are unblocked.
Let the unit cool down for 5-10 minutes and then switch
it on again. Do not block the air inlets during operation
of the hot air styler and avoid getting of hair into the air
inlet grid (5).
CLEANING AND MAINTENANCE
• The hairdryer is intended for household use only.
• Set the switch (1) to the «0» position, disconnect the
hairdryer from the mains and let it cool down.
• Wipe the unit body (4) with a slightly damp cloth, and
then wipe it dry.
• Clean the air inlet grid (5) with a brush.
• Do not immerse the unit into water or any other liquids.