AV90
Installation
12
1/21/2014
Bradley
• 215-1773 Rev. D; ECN 13-08-028
2
Frame and Bowl Assembly
When installed properly, the basin will be level and flush to the back wall.
For clarity, the pre-mounted soap spout, faucet spout,
dryer hood and air hoses are not shown.
If access through the basin is preferred, the dryer hood cover
must be removed. Refer to Step 4 for removal instructions.
A
Position the basin
onto the frame. The
right vertical frame
support will fit into
the basin notch as
shown.
B
Secure the basin flange
to the back wall using
suitable
³⁄₈
" fasteners
supplied by the installer.
Access the basin
flange from the
underside or through
the dryer hood
access hole. Refer
to page 12 for dryer
hood cover removal
instructions.
C
Secure the bowls to the frame
with the six ¼"-20 x
³⁄₈
" screws
(p/n 160-389) and washers
(p/n 142-002DB) provided.
Use the back
basin flange
as a template
to mark the
(2) mounting
hole locations
onto the wall.
After marking
the wall, install
suitable wall
anchors. See
step 1b.
Drain Cap Assembly
(S45-2714)
Drain Adapter
(111-091)
#10 Screw
P10-225
O-Ring
(125-111)
Packing Washer
(142-135)
P-trap
3
Drain and P-Trap
For clarity, the soap spout, faucet spout, dryer
hood and frame are not shown.
Do not overtighten the
screws on the drain adapter!
A
Install p-trap outlet to
stub out from wall.
B
Assembly o-ring, drain
adapter and packing
washer to basin hub
with (4) #10 screws.
C
Attach p-trap to
outlet and drain.
P-Trap Outlet
D
Use
⁵
⁄
₆₄
" hex driver to
install screw to drain
cap assembly.
