Boston Whaler 370 Outrage, Руководство пользователя, Страница: 113 / 204

3-33
Section 3 • Systems & Components Overview & Operation
370 Outrage
R
Section 3 • Systems & Components Overview & Operation
Single Cord Shore Power
In some cases you may be limited to operating your
boat’s equipment utilizing only a single shore power
cord. The following procedure will provide the most
effi cient power to the boat.
• Slide the covers
on the panel to
expose the
GENERATOR
& SHORE
POWER #2
breakers.
• make sure the breakers are OFF.
• Assure that ALL
component
breakers are
OFF.
• Using the shore
cords, (supplied)
c o n n e c t t h e
female plug to
the boat
receptacle fi rst.
• Next connect the
male plug to the
dockside panel.
SHORE
POWER 2
O
N
GENERATOR BRIDGE
SHORE
POWER 1
O
N
O
N
O
N
O
N
O
N
O
N
O
N
OUTLETS
12V BATTERY
CHARGER
A/C
SHORE POWER 1 120V 60HZ
BLOWER
On/Off
Start
Stop Alarm
Mute Next
Screen
Set
LEANING
POST
WATER
HEATER
MICROWAVE
SHORE POWER 2 120V 60HZ
FISHBOX
FREEZER
A/C PUMP
WARNING !
GASOLINE VAPORS
CAN EXPLODE
BEFORE STARTING
GENERATOR:
- CHECK FOR
GASOLINE VAPORS
- OPERATE BLOWER
FOR 4 MINUTES
NOTE: RUN BLOWER
BELOW CRUISE
SPEED.
24V BATTERY
CHARGER
The single cord shore power scenario described
in the previous column utilizes the generator to
supplement power. Although this setup provides
maximum voltage to your boat, you may fi nd at times
that the generator noise is too interruptive. You can
still power your boat suffi ciently by utilizing the
breakers as follows:
• Slide the covers
on the panel to
expose the
SHORE POWER
#1 & BRIDGE
breakers.
• make sure the breakers are OFF.
• Proceed with setup as described on the
previous page.
Battery Charging
In addition to supplying AC power to your boat, shore
power hookup gives you the ability to charge your
batteries without running the engines.
The system is automatic and little or no maintenance
is required. The battery charger can be accessed
through the equipment hatch in the aft cockpit
deck.
Shore Power Load Management
Your boat is equipped with many devices that require
AC power for their operation. While many of these
devices are continuous use items, others are not.
The design of the electrical system has been optimized
to support the most commonly used equipment.
However, there may be situations where the operator
will need to power off certain appliances based on
load requirements, shore power connections and/or
generator operation.
SHORE
POWER 2
O
FF
O
FF
O
N
GENERATOR BRIDGE
SHORE
POWER 1
O
N
O
N
O
N
O
N