Bosch UHI Series, Руководство по эксплуатации

Страница: 16 / 36

Conductor type Stranded 20 to 16 AWG
Conductor insulation Color-coded
Table 4.5: Lens control cable specifications
Housing mounting
1. Use two 1/4-20 x 0.50 in. screws and 1/4 in. spring washers to mount the housing to a
mount or a pan/tilt. The spring washers must be used for the screws to thread properly.
2. The outermost set of 1/4-20 threaded holes are for mounting to feed-through mounts,
and the innermost 1/4-20 holes are for mounting to all other mounts and pan/tilts.
Figure 4.1: Thread holes for mounting with rear connections, or for feed through wiring
1 For mounting with rear connections
2 For mounting with feed-through wiring
Opening the cover
!
Warning!
The heater will be HOT when in operation - DO NOT TOUCH. Always switch heater OFF when
working on the camera.
Open the cover by unlatching the three latches on the side of the housing. If the optional
tamper-resistant screws have been installed, use the supplied wrench to remove the screws
before opening the latches.
4.3
4.4
16 en | Installation UHI/UHO Series Camera Housing
2014.05 | 4.0 | F.01U.167.418 Operation Manual Bosch Security Systems, Inc.