Bosch Rexroth Nexo, Руководство пользователя

Страница: 64 / 279

64
/279
Bosch Rexroth AG
| Tightening Technology
3 608 870 A47
Nexo cordless Wi-Fi nutrunner
| 3 608 870 A47/2019-10
Ack0-7 Acknowledge 0-7: Acknowledges program selection
The signal serves to acknowledge the program selection.
With the help of these signals, the PLC can determine whether the tightening program was selected
successfully. The program number is only valid if the acknowledgement corresponds to the selection. The
controller always uses the acknowledged program number as the basis for a tightening.
ActEnAck Active Enable: Acknowledges enabling of a single tightening process
The signal serves to confirm that the tightening channel has been enabled for a single tightening process.
ActScanAck Active Scanner: Acknowledges enabling of a single scan process
The signal serves to confirm that the scanner integrated into the nutrunner was enabled for a single scan
process.
AnglH Angle too high: Angle too high
Results description after a completed tightening sequence. The angle is above the defined tolerance
window.
AnglL Angle too low: Angle too low
Results description after a completed tightening sequence. The angle is below the defined tolerance
window.
AppOut0-15 Application Out Bit 0-15: Application-specific output signal
Application-specific signals are used to make special adjustments for customer requirements. They are,
e.g., suitable for looping through signals: a signal can be read by the controller via interface modules and
then output to the partner controller using the controller.
BattOK Battery OK: State of the battery pack slide-in module
This signal repors the state of the battery pack slide-in module.
BattOK
= „High“: The battery state is okay. As soon as the battery charge condition does not allow
tightening any longer or if the battery is defective, the signal changes to "low".
BattOff Battery Off: Battery pack slide-in module not inserted
This signal reports whether or not the slide-in battery pack is inserted.
BattOff
= “High”: The battery is not inserted. The signal changes to "low" when the battery is inserted.
CntSelAck0-7 Counter Select acknowledge Bit 0-7 Acknowledge counter set selection
These signals are used to acknowledge the counter value selection via signals
CntSel0-7
. Signal
CntSelAck0-7
is output only if the
Select PLC signals CntSel0...CntSel7
option is selected in the OK/
NOK counter.
CcwAck Counter clock wise acknowledge: Acknowledges a loosening operation
This signal confirms that the tightening program No. 99 (Loosen) has been started in a tightening channel.
CntCanceled Counter canceled: Counter set canceled
Cancelation of a counter set is indicated by CntCanceled is "high". The
CntCanceled
signal is output
only if the program is changed within a non-completed counter value. The
Select PLC signals
Pro0...Prog7
option must be selected in the OK/NOK counter.
CcwLockAck Counter clock wise lock acknowledge: Acknowledges that loosening is disabled
This signal acknowledges the locking of the tightening program no. 99 (Loosen) in a tightening channel.
CCwSel Counter clock wise Select: Loosening program selected at nutrunner
This signal changes to "high" when program no. 99 (Loosen) is selected using the program selector on
the nutrunner.