Bosch ICP-EZM2, Справочное руководство системы

Страница: 33 / 126

Easy Series Programming Access Options | en 33
Bosch Security Systems, Inc. System Reference Guide F01U087835 | 02 | 2008.10
4 Programming Access Options
You can access the system to make programming changes using:
– The Phone Menu
– Remote Programming Software (RPS)
– A Programming Key (using programming copied from a control panel previously
programmed using the Phone Menu or RPS)
4.1 System Access by Phone
The Installer Phone Menu and User Phone Menu provide access to system functions such as
testing the system, programming the system, and adding or changing users.
The Installer Phone Menu requires the installer passcode.
The User Phone Menu requires either the master user (User 1) passcode for full menu access,
or a user passcode for limited menu access.
If the passcode length = four digits:
– The default installer passcode is 5432
– The default master user passcode is 1234
If the passcode length = six digits:
– The default installer passcode is 543211
– The default master user passcode is 123455
To access the system menus, select one of the options shown in Table 4.1 , Page 33.
Table 4.1 Phone System Access Options
i
NOTICE!
Once you configure a control panel using the Phone Menus, you can copy the programming
from the control panel to a programming key for use on another control panel, or for backup.
Refer to Section 4.3 Programming Keys , page 36.
Options Steps
House Phone – Press [#][#][#].
– Listen for the voice prompt to enter a passcode.
– Enter the installer passcode to access the installer menu, or a user passcode to access
the user menu.
Outside Phones – Call the premises phone number.
– After the call is answered by a person or by a telephone answering device, press
[*][*][*] to disconnect the answering party and access the system.
– Listen for the voice prompt to enter a passcode.
If the phone is not answered by a person or telephone answering device, the system
answers after a programmed number of rings. Refer to Expert Programming Item
Number 222 listed in on Section Route Destination Items , page 47.
– Enter the installer passcode to access the installer menu, or a user passcode to access
the user menu.
Installer Quick
Connect
Select this option if a phone line is not available, or a local connection is required. The
system must be off to use this option.
– Connect a phone set to the test posts or to the phone terminals.
– Press and hold the System Test button for approximately 15 sec.
– Listen for the voice prompt to enter a passcode.
– Enter the installer passcode to access the Installer Menu, or a user passcode to access
the User Menu.