Bosch HPC 410, Инструкция по установке для подрядчиков

Страница: 20 / 24

Overview of the service menu
HPC 410 – 6721832682 (2021/02) 20
9 Overview of the service menu
The menu items are displayed in the sequence below.
Service menu
Commissioning
– Country information
– Buffer cyl.
– Start configuration wizard
– Enter regional minimum outside temperature.
– VC0 valve connected
– Select add. heat appliance
– Mixed aux. heat. conn
– Add. el. heater op. mode
– Fan speed
– Supply air heat. by heat p.
– Heating circuit 1 installed
– Config. HC1 at HP
– Priority heating circuit 1
– Mixer heating circuit 1
– Mixer runtime heat circ. 1
– Heating system heat circ. 1
– Ctrl type h. circ. 1
– Rem. ctr. heat. circuit 1
– Heating circuit 2 installed... Heating circuit 4 installed
– DHW install.
– DHW circ.pump installed
– Size of freshwater station
– Freshwater station 2... 4
– Change freshwater configuration
– Ventilation installed
– Sol.therm.sys. instlld
– Solar extension module
– Pool mixing valve
– Electr. anode in cylinder
– Fuse size
– Confirming configuration
Heat pump
– On/off hysteresis
– Heating
– Set on/off hysteresis in cooling mode.
– Pool
– Stand-alone mode
– Pumps
– Prim. heating pump mode
– Minimum flow rate
– External connections
– External connection 1
– Logic ext. connection 1
– Block compr. operation
– Block HW operation
– Block heating mode
– Block cooling mode
– Overheat. protection HC1
– ESC blocking time1 on
– ESC blocking time2 on
– ESC blocking time3 on
– Block additional heater
– PV system
– External connection 2
– External connection 3
– External connection 4
– Fuse size
– Manual defrosting
– Smart grid
– Heating
– Selectable peak
– Forced peak
– DHW
– Selectable peak
– PV system
– Heating peak
– DHW peak
– Cooling setback mode
– Only cool with PV
– Fixed temperature
– Central fault
– Low-noise operation
– Low-noise operation
– Low-noise operation of
– Low-noise operation until
– Min. outside temp.
Set additional heater
– Gen. additional heater settings
– Select add. heat appliance
– Additional heater on delay
– Mode after EVU block
– Auxiliary heater only
– Switch off add. heater
– Max. add. heater temp.
– Maximum limit
– Limit start
– Electric auxiliary heater
– Add. el. heater op. mode
– Lim. with compressor
– Limit add. heater output
– Limit DHW mode output
– Outdoor temp. limit
– Bivalence point
– Auxiliary heater with mixer
– Mixed aux. heat. conn
– Delay time for mixer
– Mixer run time
– Alarm input logic
– Outs. temp par. mode
– Bival. pt. parallel mode
– Outdr temp switch mod
– Bival. pt. switch mode
– Add. heater DHW cylinder
Set heating/cooling
– System data
– Buffer cyl.
– Config. HC1 at HP
– Internal heating pump
– Min. outside temp.
– Damping
– Building type