Bosch HNG6764.1A, Инструкция по эксплуатации

Страница: 23 / 76

Steam
en
23
7.
Reinsert the cover
‚
into the opening in the water
tank.
8.
Insert the filled water tank (Fig.
%
). Ensure that the
water tank locks into place behind both holders
ƒ
(Fig.
&
).
9.
Slowly push the control panel downwards and then
towards the rear until it is closed completely.
The water tank has been filled. You can start
operations with steam.
Refilling the water tank
If the water tank runs dry during a steam operation, a
message appears on the display prompting you to fill
up the water tank.
Notes
■
Steam-assisted operations continue without adding
steam.
■
If the water tank runs dry during the operation with
the Dough proving or Reheating settings, the
operation is interrupted. Fill the water tank.
1.
Open the control panel.
2.
Remove and refill the water tank.
3.
Insert the filled water tank and close the control
panel.
After every steam operation
:
Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:
Warning – Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
The remaining water is pumped back into the water
tank after every operation with steam. Then empty and
dry the water tank. Moisture remains in the cooking
compartment. To dry the cooking compartment, you
can either use the "Drying" operating mode or dry the
cooking compartment by hand.
Notes
■
Once the appliance has been switched off, the
v
field remains lit for a little longer to remind you to
empty the water tank.
■
Remove limescale marks with a cloth soaked in
vinegar, then wipe with clean water and dry with a
soft cloth.
Emptying the water tank
Caution!
■
Do not dry the water tank in the hot cooking
compartment. This will damage the water tank.
■
Do not clean the water tank in the dishwasher. This
will damage the water tank.
1.
Open the control panel.
2.
Remove water tank.
3.
Carefully remove the lid of the water tank.
4.
Empty the water tank, clean it with detergent and
then rinse it thoroughly with clean water.
5.
Dry all parts with a soft cloth.
6.
Rub the seal on the lid until dry.
7.
Leave to dry with the lid open.
8.
Place the lid on the water tank and push it down.
9.
Insert the water tank and close the control panel.
Cleaning the drip trough
1.
Allow the appliance to cool down.
2.
Open the appliance door.
3.
Wipe around the drip trough
‚
underneath the
cooking compartment with a sponge cloth (fig.
!
).
Starting drying
During drying, the cooking compartment is heated up
so that the moisture in the cooking compartment
evaporates. Then open the appliance door so that the
steam escapes.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
E
E
I
D
1