48
| English
1 609 929 X56 | (22.1.11)
Bosch Power Tools
Adjusting:
– Loosen Allen screws
59
at the front below
the saw table and Allen screws
60
at the rear
below the saw table with the supplied Allen
key
21
.
– Carefully move the saw blade until it is paral-
lel to guide groove
5
.
– Retighten all screws
59
and
60
again.
Adjusting the Saw Table’s Clearance Indicator
(see figure V)
– Position the parallel guide on the right side
of the saw blade.
Move the parallel guide until the mark in the
lens
27
indicates 26 cm on the bottom scale.
To lock the parallel guide, press clamping
handle
35
down again.
– Loosen tensioning lever
15
and pull the table
extension out to the stop.
Checking:
On the upper scale
1
, clearance indicator
51
must indicate the identical value as the mark in
lens
27
on the bottom scale
1
.
Adjusting:
– Loosen screw
61
with a Phillips screwdriver
and align clearance indicator
51
alongside
the 26 cm mark of the upper scale
1
.
Adjusting the Lens of the Parallel Guide
(see figure W)
– Bring the power tool into the working posi-
tion.
– Tilt the protection guard
6
toward the rear to
the stop.
– Move parallel guide
10
from the right until it
touches the saw blade.
Checking:
The mark of lens
27
must be in a line with the 0°
mark of scale
1
.
Adjusting:
– Loosen screw
62
using a Phillips screwdriver
and align the clearance indicator alongside
the 0° mark.
Adjusting the Level of the Insert Plate
(see figure X)
Checking:
The front side of the insert plate
24
must be
flush with or somewhat lower than the saw ta-
ble; the rear side must be flush with or some-
what above the saw table.
Adjusting:
– Remove the insert plate
24
.
– Adjust the correct level of the four adjusting
screws
63
with the Allen key
64
.
OBJ_BUCH-1325-001.book Page 48 Saturday, January 22, 2011 12:54 PM
