44
| English
1 609 929 X56 | (22.1.11)
Bosch Power Tools
f
When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Mount the clamping flange
44
and the clamp-
ing nut
42
.
– Turn the clamping nut
42
with the ring span-
ner
22
(23 mm) and at the same time, pull
the spindle lock lever
43
until it engages.
– Tighten the clamping nut in clockwise direc-
tion. (Tightening torque approx. 15–23 Nm)
– Reinsert the insert plate
24
.
– Tilt protection guard
6
down again.
Operation
f
Before any work on the machine itself, pull
the mains plug.
Transport and Working Position of the
Saw Blade
Transport Position
– Turn the handwheel
18
in anticlockwise di-
rection until the teeth of the saw blade
26
are positioned below the saw table
9
.
– Slide the table extension
14
completely in-
ward.
Press tensioning lever
15
downward.
The saw-table extension is now locked.
For additional information on transport, see
page 49.
Working Position
– Turn the crank
19
clockwise, until the teeth
of the saw blade
26
are positioned above the
workpiece.
Note:
Take care that the blade guard is properly
positioned. When sawing, it must always face
against the workpiece.
Adjusting the Cutting Angle
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use (see “Checking
and Adjusting the Basic Adjustment”, page 47).
Adjusting Bevel Angles
(Saw Blade) (see figure K)
The bevel angle can be set in the range from –2°
to 47°.
– Turn locking lever
17
in anticlockwise direc-
tion.
Note:
By completely loosening the locking knob,
the saw blade tilts approx. to the 30° position
by means of gravity force.
– Push or pull handwheel
18
alongside the con-
necting link until the angle indicator
47
indi-
cates the desired bevel angle.
– Hold the handwheel in this position and
tighten locking lever
17
again.
For quick and precise setting of the standard
0° and 45°
angles, factory-set stops have been
provided for.
Adjusting Mitre Angles
(Angle Stop) (see figure L)
The mitre angle can be set in the range from 60°
(left side) to 60° (right side).
– Loosen the locking knob
49
in case it is tight-
ened.
– Turn the angle stop until the angle indicator
50
indicates the requested mitre angle.
– Tighten the locking knob
49
again.
Increasing the Size of the Saw Table
(see figure M)
Long workpieces must be underlaid or support-
ed at their free end.
– Completely pull tensioning lever
15
of the
saw-table extension upward.
– Pull out the saw-table extension
14
to the de-
sired length.
– Press tensioning lever
15
downward.
The saw-table extension is now locked.
OBJ_BUCH-1325-001.book Page 44 Saturday, January 22, 2011 12:54 PM
