English–7
3 609 929 A68 • 12.7.06
Overload Clutch
f
If the tool insert becomes caught or jammed,
the drive to the drill spindle is interrupted.
Because of the forces that occur, always hold
the power tool firmly with both hands and
provide for a secure stance.
Control Indicator
The control indicator
1
flashes
:
The power tool is operating in the
overload range.
Reduce the feed pressure. If
required, switch the machine off
and sharpen the core bit.
When the feed pressure is not
reduced, the electronic control
will reduce the speed. In case of continued overload,
the power tool switches off. Free the load on the power
tool and switch on again.
The control indicator
1
lights up
continuously
:
The carbon brushes must be
replaced.
A Bosch after-sales service sta-
tion will handle this maintenance
task quickly and reliably.
Removing the Core
GDB 1600 WE with flusing head
6
: After drilling, con-
tinue to run the water for a short period in order to flush
out the drilling sludge between the core bit and the
core.
If the drilling core is stuck in the core bit, then apply
light blows onto the core bit with a piece of soft wood
or plastic in order to loosen the core. If required, pry the
drilling core out of the core bit using an appropriate
hand tool (slotted screwdriver or similar).
Note:
Do not hammer or apply blows onto the core bit
with hard objects (danger of deformation)!
Maintenance and Service
Maintenance and Cleaning
f
Before any work on the machine itself, pull
the mains plug.
f
For safe and proper working, always keep the
machine and ventilation slots clean.
Clean the drilling spindle
13
after finishing work. Occa-
sionally spray an anti-corrosion agent onto the drilling
spindle and the core bit
12
.
If the machine should fail despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by an after-sales service centre for Bosch
power tools.
In all correspondence and spare parts order, please
always include the 10-digit article number given on the
type plate of the machine.
Accessories/Spare Parts
Flushing head . . . . . . . . . . . . . . . . . . . . 2 609 390 397
Suction head . . . . . . . . . . . . . . . . . . . . . 2 609 390 398
Diamond drill stand S 500 A . . . . . . . . 0 601 190 025
Operation with GDB 1600 WE:
•
Water collection ring . . . . . . . . . . . . 2 609 390 310
•
Sealing disc for water collection
ring . . . . . . . . . . . . . . . . . . . . . . . . . . 2 609 390 311
Water-pressure container . . . . . . . . . . 2 609 390 308
Hose coupling ASK 1/2 . . . . . . . . . . . . 0 600 802 009
Sliding ring . . . . . . . . . . . . . . . . . . . . . . . 1 600 190 042
Extension 300 mm:
•
for core bit R 1/2" . . . . . . . . . . . . . . 2 608 598 044
•
for core bit 1 1/4" UNC . . . . . . . . . 2 608 598 045
OBJ_BUCH-116-001.book Page 7 Wednesday, July 12, 2006 12:52 PM
