Bosch FWI-270, Руководство по эксплуатации

Страница: 43 / 54

Radio gateway Maintenance / troubleshooting | en 43
Bosch Sicherheitssysteme GmbH Operation Manual 2019.10 | 2.0 | F.01U.373.488
Only confirm with 'OK' once you have switched gateways.
Now switch gateways by connecting the 3.5 mm jack cable to the new gateway.
1. Confirm the successful data transfer with 'OK'.
2. The new radio gateway automatically has the net ID of the old radio gateway.
3. Check whether the LED (H4) is flashing.
4. Overwrite the net ID of the new radio gateway with the net ID of the old radio gateway on
the type plate.
5. Wait until LED (H4) stops flashing. This can take up to 30 minutes depending on the size
of the radio cell.
6. Install the new radio gateway at the location of the old radio gateway.
7. Establish a cable connection to the LSN line.
8. Switch the LSN line on.
9. Dispose of the old, unusable radio gateway in an environmentally friendly manner.
NOTICE! If you want to reuse the radio gateway, note the information at the beginning
of this chapter.
P
The radio gateway is replaced.
7.6 Basic principles for replacing the battery pack
WARNING
Risk of explosion due to fire or short-circuit, even with a
discharged battery pack
Injury due to flying parts
–
Isolate the connections and attach the battery cable to the
battery pack to avoid a short-circuit of the connection wires.
– Prevent the battery pack from coming into contact with water.
– Do not extinguish a burning battery pack with water.
– Do not recharge the battery pack.
– Do not damage or disassemble the battery pack.
– Do not heat the battery pack to over 100°C.
WARNING
Disposal of damaged or leaking battery pack
Lithium can cause skin burns and create toxic vapors.
–
Avoid direct skin contact.
– Wear protective clothing, such as protective gloves and goggles.
– Avoid breathing in the vapors. Ensure good ventilation.
– Use a suitable means of transport to transport damaged
batteries.