DIVAR IP 6000 (3U)
Maintenance | en
35
Bosch Sicherheitssysteme GmbH
Installation Manual
2016.08 | V2.1 | DOC
10.3
Removing the chassis cover
1
1
2
2
3
1
Fixing screws
3
Chassis cover
2
Release tabs
To remove the chassis cover:
1.
Disconnect the power supply, lay the chassis on a flat surface.
2.
Remove the two screws on each side of the cover, which secure the cover to the chassis.
3.
Press the release tabs to remove the cover from the locked position. Press both tabs at
the same time.
4.
Once the top cover is released from the locked position, slide the cover toward the rear
of the chassis and lift the cover off the chassis.
Notice!
Except for short periods of time, do NOT operate the server without the cover in place. The
chassis cover must be in place to allow proper airflow and prevent overheating.
10.4
Installing a SATA hard drive
This chapter describes the removing and installing of SATA hard drives.
10.4.1
Removing a hard drive from the chassis
The hard drives are mounted in hard drive carriers to simplify their installation and removal
from the chassis. These hard drive carriers also help promote proper airflow for the hard drive
bays.
