Do not attempt to disas-
semble the battery or
remove any com ponent projecting from the
battery terminals.
Fire or injury may result.
Prior to disposal, protect exposed terminals
with heavy insulating tape to prevent shorting.
Lithium-ion Batteries
If equipped with a lithium-ion battery, the
battery must be collected, recycled or disposed
of in an environ mentally sound manner.
“The EPA certified RBRC
Battery Recycling Seal on the
lithium-ion (Li-ion) battery
indicates Robert Bosch Tool
Corporation is voluntarily
participating in an industry
program to collect and recycle these batteries
at the end of their useful life, when taken out
of service in the United States or Canada. The
RBRC program provides a convenient
alterative to placing used Li-ion batteries into
the trash or the munici pal waste stream, which
may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool
Corporation’s involvement in this program is
part of our commitment to preserving our
environment and conserving our natural
resources.”
!
WARNING
AN exTeNSIoN CoRD
SHoULD NoT Be USeD
UNLeSS ABSoLUTeLy NeCeSSARy.
Use
of improper extension cord could result in risk
of fire and electrical shock. If an extension cord
is used, make sure:
a.
The pins on plug of extension cord are the
same number, size, and shape as those of plug
on charger.
b.
The extension cord is properly wired and in
good electrical condition.
c.
The wire size is large enough for AC ampere
rating of charger as specified below:
d.
An extension cord is a temporary solution.
Move the charger to a standard receptacle as
soon as the job has been completed.
Length of
Cord, Feet
25
50
100
150
AWG Size
of Cord
18
16
16
14
Extension Cord Chart for 220/240 Volt Tools:
0.75mm
2
CORD
50 Meters
1.0mm
2
CORD
75 Meters
!
WARNING
extension Cords
Battery Disposal
The lithium ion battery is protected against
deep discharging by the “Electronic Cell
Protection (ECP)”. When the battery is empty,
the tool is switched off by means of a
protective circuit.
The battery is supplied partially charged.
Completely charge the battery before using your
cordless screwdriver for the first time. The lithium
ion battery can be charged at any time, without
reducing its service life. Interrupting the charging
procedure does not damage the battery.
electronic Cell Protection (eCP)
-4-
BM 2610033170 08-13_BM 2610033170 08-13.qxp 8/13/13 1:21 PM Page 4