Bosch B450, Инструкция по установке и эксплуатации

Страница: 34 / 49

34 en | Configuration Conettix Plug-in Communicator Interfaces
2017.10 | 09 | F.01U.300.740 Installation and Operation Guide Bosch Security Systems, Inc.
5. Product
Versions Shows the version information for the B450. For example:
*** Product Versions ***
B450 Product ID: 88096.16041400007
B450 Application: V 3.01.032
B450 Boot Loader: V 1.05.001
B450 Hardware: V 1.00.000
RTOS: V 3.03.600
Fusion Stack: V 8.07.5603
Cellular Manager: V 2.00.3203
UPKI Encryption: V 3.03.002
AES Lib: V 01.00.000
Modem Firmware: V 15.00.021
See also
– Firmware updates, page 38
– Diagnostic log, page 44
5.3.5 Basic and Advanced Configuration menus
Use the figure in Main Menu, page 28 to locate the configuration option you want to set. Enter
the corresponding numbers to access the option. For example, press [3] [1] for [3] Basic
Configuration > [1] TCP/UDP Port Number. Use the on-screen prompts to set the
configuration.
For detailed information on the configuration options, refer to
Configuration parameters, page
17 .
USB Configuration important notes
– TCP/UDP Port Number Character limitations. Enter the 32 digit encryption key. Verify the
32 digit key does not exceed the arrow prompt, as shown in the figure above. Use only
hex values 0-9 and A-F.
– SIM PIN. To erase text, you must type in the word None to erase the previous text. This is
NOT case-sensitive.
See also
– Configuration parameters, page 17
5.4 SMS configuration
The B450 supports configuration by SMS connection on a mobile phone or other device that
sends SMS text messages. To use this feature, enable the
Inbound SMS parameter.
The SMS string follows a specific format. If the configuration message exceeds 160
characters, you must send multiple messages. The B450 applies the configuration when it
receives the final valid part of an SMS message.
Entering CONFIG mode
For the B450 to receive SMS messages, you must set the address switch to 0. With other
addresses, the B450 discards incoming SMS.
For detailed information on the configuration options, refer to
Configuration parameters, page
17 .
5.4.1 Creating the SMS
1. Use the SMS information in this section to write the SMS.
2. For SMS that need more than 160 characters, refer to Multiple SMS messages, page 36 .