Bosch B450, Инструкция по установке и эксплуатации

Страница: 31 / 49

Conettix Plug-in Communicator Interfaces Configuration | en 31
Bosch Security Systems, Inc. Installation and Operation Guide 2017.10 | 09 | F.01U.300.740
Signal Strength Shows the current signal strength: Very good, Good, Marginal,
Unacceptable, or Unavailable.
Bus Status
Bus Type Shows the current bus type: SDI2, SDI, Option, or None.
Bus Address Shows the current bus address: 1, 2, 88, 92, 134, or 250.
Bus Voltage Shows the current voltage: Good or Low.
Module Status - This status shows only if there is a trouble condition.
– B44x Plug-in Missing
– Detecting Plug-in
–
B44x Plug-in Missing
– B44x Plug-in Invalid
– No IP Address
– Detecting Plug-in
– Signal Strength Low (if configured)
– Too Few Towers
– No Towers (if configured)
– B44x Not Active
– B44x Failure
– Configuration Failure
– Low Bus Voltage
– No Bus Communication
– Switch in Position 0
– Firmware Checksum Error
– Configuration Checksum Error
– SIM Missing
– SIM PIN Wrong
– SIM PIN Lockout
– Invalid Access Point
– No IP Address
Advanced Status Menu
The following section describes the Advanced Status menu parameters.