Bosch AutoDome Easy II IP, Руководство по установке

Страница: 48 / 144

48 en | Installing a Recessed Mount AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
6.1.3 Installing the Camera to the Mounting Plate
To install the base to a surface or suspended ceiling using the
supplied mounting plate, do the following:
1. Use supplied T-10 key to loosen (do not completely
remove) the three (3) screws on dome bubble. Remove
trim ring and set aside.
2. Re-tighten screws.
3. Route wires on side of mounting plate with crescent
shaped cut-out (Ref. #4 Figure 1.2).
4. Attach grounding wire from unit to the mounting bracket.
5. Attach user supplied ground to junction box.
6. Connect the mating connectors with the flying leads to the
user supplied wiring (see the Section 8 Preparing the
Wiring, page 63 for wiring information).
7. Remove the single safety locking screw on the base of the
unit using the user-supplied Allen wrench.
Figure 6.5 Unlock Safety Locking Screw
NOTICE!
Over torquing the ceiling clamps can damage the clamp or
ceiling. Only tighten the clamp until it contacts the ceiling and
you start to feel some resistance. If using a power screwdriver,
set the torque level to the lowest setting.
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.