4.6
Float
The float is a safety device which starts the drain pump if there’s
too much water in the tank.
4.7
Water inlet / condensation system
Unlike prior dishwashers, Ascenta dishwashers use a common
water inlet and condensation system. Instead of feeding water
into the bottom of the tank, dishwashers fill into the left side of the
tank. Instead of condensation exiting from the right side of the
tank, it exits the left side of the tank through the water inlet.
There are three hoses connected to the water inlet system, the
water inlet hose (from the water inlet valve), condensation
(breather) hose and internal drain hose. The internal drain hose
has a factory made high loop (~ 15” above the floor) and
connects to the external customer drain hose.
Ascenta dishwashers use a time-fill.
Maximum customer (external) drain hose length is 92”.
Water inlet system and hoses are shown below.
1
2
3
4
2
1
1. Condensation tube
2. Drain hose (with high loop)
3. Water inlet hose
1. Float assy.
4. Water inlet
2. Float (located inside
of tank)
Drain hose high loop and left side condensation exit are shown
below.
702_58300000130262_ara_en_c
Page 14 of 50
