7. Carefully pull the float lever from the housing
(below left)
.
8. Carefully pry the microswitch from the housing
(below
right)
.
9. Push the float into the tank and remove it
(below)
.
5.14 2-piece drain hose connection
Drain hoses come in two pieces, an external (customer) drain
hose and an internal drain hose. The 90º elbow of the external
hose is connected to the outlet of the internal hose (pointing
toward the drain) and is held in place by a hose clamp.
5.14.1 Removing internal drain hose
Tools needed: #2 Phillips & small flat blade screwdrivers.
1.
Remove toe kick
– section 5.1.4.1.
2.
Flip dishwasher for access
– section 5.1.6.1.
3. Lift off the white plastic hose lock at the sump (near the
drain pump) and pull out the drain hose w/ O-ring
(below)
.
4. Carefully pry out the white plastic hose lock at the rear of
the dishwasher where the external drain hose connects to
it
(below center)
and slide the hose out from the bracket
(below right)
.
1. Drain hose lock
1
702_58300000130262_ara_en_c
Page 35 of 50
