5.9
Inner doors
Inner doors rarely need to be removed for repairs, but need to be
removed to access the lower door seal and door hinge lever.
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers.
1.
Remove outer door
– section 5.1.2.1.
2.
Remove toe kick
– section 5.1.4.1.
3. Remove base insulation (on models with insulation).
4.
Disconnect & pull out dishwasher
– section 5.1.4.2.
Pull dishwasher out enough to clear hinges.
5.
Remove fascia panel
– section 5.1.2.2. This eliminates
disconnecting and reconnecting all wire harnesses.
6. If replacing inner door,
remove dispenser
– section 5.3.1.
7. If the lower door seal sticks to the inner door, separate the
seal from the door by hand
(below left)
.
8. Disconnect door springs from hinge levers
(below center)
.
9. Remove two (2) hinge screws on both sides of inner door
(below)
. The bottom screws also hold the lower door seal.
5.10 Door hinge levers
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers.
1.
Remove inner door
– section 5.9.
2. Remove right hinge ground wire
(below left)
.
3. Pry open hinge bushing latches and lift hinge levers from
hinge plates. Hinge bushings should be replaced after
latches have been pried open.
702_58300000130262_ara_en_c
Page 32 of 50
