bora PKCH3, Инструкции по эксплуатации и монтажу

Страница: 21 / 36

EN
21
Installation
www.bora.com
5.8.3 Connecting the power supply
X
X
Observe all national and regional laws and regulations as
well as the supplementary regulations of the local utility
companies.
i
The appliances may only be connected to the mains
power supply by certified specialists. The specialist also
assumes responsibility for the proper installation and
commissioning.
Connecting the cooktop to the power supply
The power supply cable to be used (already pre-installed) must
comply with certain, appliance-specific requirements (see table
“Fuse protection and minimum cross-section”).
i
A damaged power supply cable must be replaced by
another suitable power supply cable. This may only be
done by an authorised member of the After Sales Service
team.
Power supply cable requirements and connection diagram
Connection Fuse
protection
Minimum
cross-section
Power supply
cable
1-phase
connection
1 x 25 A 2.5 mm²
Type H05V2V2-F
2-phase
connection
2 x 16 A 2.5 mm²
Type H05V2V2-F
Tab. 5.4 Fuse protection and minimum cross-section
1
L1
2 3
N PE
220 - 240 V~
Fig. 5.25 1-phase connection diagram
1
L1 L2
2
N PE
220 - 240 V~
220 - 240 V~
3
Fig. 5.26
2-phase connection diagram
Connecting the cooktop to the mains
X
X
Switch off the main switch/automatic circuit breaker before
connecting the cooktop.
X
X
Secure the main switch/automatic circuit breaker against
being switched back on without permission.
X
X
Make sure the power to the appliance is disconnected.
X
X
Only connect the cooktop using a permanent connection to a
power supply cable.
X
X
Check that installation has been carried out correctly.
X
X
Switch on the main switch/automatic circuit breaker.
X
X
Put the cooktop into operation (see the Operation chapter).
X
X
Check that all the functions are working correctly.
X
X
Connect the port on the back of the left control knob [5] to
the “zone 2” port on the cooktop [1].
X
X
Connect the port on the back of the right control knob [4] to
the “zone 1” port on the cooktop [1].
X
X
Using the configuration menu, set the correct allocation of the
cooking zones in the control knob display (see configuration
menu – 0° or 180° installation).
5.8.2 Establishing contact between the
cooktop extractor and cooktops
2
ZONE1 INTERF. COM1 ZONE2
1
ZONE1 INTERF. COM1 ZONE2
3
Fig. 5.24 Establishing contact between the cooktop extractor
and cooktops
[1] Cooktop extractor communication cable ports (x 2)
[2] Cooktop communication cable port
[3]
Ribbon cable
X
X
Using the communication ports provided, connect the
cooktop extractor [1] to the cooktop or cooktops [2].
X
X
Only use the cables supplied in the scope of delivery.
i
The full range of functions on the appliances will only
be available if the cooktop extractor and cooktops are
connected correctly.