BONFIGLIOLI ACTIVE ACT2 Series, Быстрый старт

Страница: 84 / 258

82
Quick Start Guide ACT
12/20
GB
• Note the warnings or error messages upon completion of the parameter
identification.
No signal is present at digital input S1IND. If a signal was
already applied at the beginning of the guided
commissioning, the "S1Ind" message is not displayed.
The parameter identification feature of the frequency inverter
requires the presence of a signal at digital input S1IND for release
of the power unit.
• Confirm the final "rEAdY" message by pressing the
ENT key.
Cancelling the operation with the ESC key or withdrawing
the enable signal S1IND results in an incomplete take-over
of the values.
In the case of more demanding requirements regarding the
accuracy of the speed/torque control, you should carry out the
guided commissioning procedure once again under operating
conditions because part of the machine data depends on the
operating temperature.
• During this procedure, confirm the rated machine values
already entered.
•
Confirm the "End" display by pressing the ENT key.
The guided commissioning of the frequency inverter is
terminated via a reset and the initialization of the frequency
inverter. The relay output X10 signals a fault.
After successful initialization of the frequency inverter, the
factory-set parameter
Actual Frequency
241 is displayed.
The drive is accelerated to the set
Min. frequency
418
(default 3.50 Hz) by:
•
Signals at digital inputs S1IND and S3IND
• Start clockwise by rising signal edge at S2IND or Start
anticlockwise by rising signal edge at S3IND