BOMBARDIER SEA-DOO GS 5626 1998, Руководство по ремонту

Страница: 67 / 426

Section 04 ENGINE
Subsection 04 (MAGNETO SYSTEM)
04-04-6
1. Uncrimp and unsolder wire here
13, Battery Charging Coil
To replace battery charging coil:
– Heat the armature plate to 93
°
C (200
°
F) around
the screw holes to break the threadlocker
bond.
1. Heat the armature plate
– Remove screws.
– Uncrimp and unsolder YELLOW and YELLOW/
BLACK wires from coil.
– Uncrimp and unsolder ground wire (BLACK)
from coil core.
1. Uncrimp and unsolder ground wire (BLACK)
2. Uncrimp and unsolder YELLOW and YELLOW/BLACK wires
Engine Crankcase Replacement
717 Engine Only
Since replacement crankcases do not have timing
mark for armature plate location, indexing marks
should be made on armature plate and crankcase
to ease reassembly and further ignition timing.
The following procedure is to find a common ref-
erence point on both crankcases (old and new) to
position armature plate.
Proceed as follows:
– Find a crankcase locating lug (the top one in this
example).
– Place a cold chisel at the end of chosen lug,
then punch a mark on armature plate at this
point.
-
CAUTION
Protect harness from flame.
A25E0QA
1
F00D09A
1
A25E0SA
1
2