Bolin Technology FEX Series, Руководство пользователя

Страница: 32 / 49

32
1. Click Setup > Events > Common Alarm > Motion Detection .
2. In the Detection Area, click to add a new detection area. To delete a detection area, click .
3. Click and drag the mouse to set a detection area.
4. Set the detection sensitivity, object size, and history for the camera to decide whether to report a motion detection
alarm.
a. Moving the slider to the right increases detection sensitivity. When the extent of motion within the detection
area exceeds the set object size, and if the duration of motion exceeds the set duration, the camera reports an
alarm.
b. Motion detection results are shown in real time. The red lines
represent the raised motion detection alarms. The longer a line,
the greater the extent of motion. The denser the lines, the
greater the frequency of motion.
5. Set the alarm parameters.
a. Suppress Alarm(s): After an alarm is triggered, the same alarm
will not be reported within the set time.
b. Clear Alarm(s): After an alarm is triggered,
i.
If the same alarm is not triggered within the set time, the alarm will be cleared and the same
alarm can be reported again.
ii.
If the same alarm is triggered within the set time, the alarm will not be cleared until the suppress
alarm time expires. Then the same alarm can be reported again.
6.
Set actions to be triggered by motion detection alarm and the plan.
a.
The following table describes the major alarm-triggered actions and how to set a plan.
b.
Alarm Output 1
i.
Select the check box. This setting is the alarm output interface linked to motion detection alarm.
1.
When an alarm is reported, the camera triggers alarm output so as to trigger actions by a
third-party device.
c.
PTZ to Preset
i.
Select the check box and set the preset linked to motion detection alarm.
1.
Make sure you have set presets. Otherwise, you cannot set this parameter. For details about
how to set a preset, see Setting Presets.