5
ASSEMBLY INSTRUCTIONS
Place all parts form the box in a cleared area and position them on the floor in front of you. Remove all packing materials
from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed.
NOTE: Don’t remove or damage the DEACL(111) located on the top of the MAIN FRAME(1).
The DECAL(111) is for preventing from the Sensor Wires drop into the Upright Tube.
STEP 1: There is a “R” decal on one end of the FRONT STABILIZER(2). Attach the FRONT STABILIZER(2)
onto the MAIN FRAME(1) with the “R” decal end at right side and secure with CARRIAGE
BOLTS(M8x70mm)(81) and NYLOCK NUTS(M8)(104).
STEP 2: Insert the STOPPER TUBE(48) through the MAIN FRAME(1) and secure with BUTTON HEAD
BOLT(M8x15mm)(94).
NOTE: The PEDAL STRAPS(47) are pre-assembled to the FOOT PEDALS(46). The pedal and strap
assembly for the left side has a “L” decal. The pedal and strap assembly for the right side has a “R”
decal.
STEP 3: Insert the PEDAL SHAFT(44) through the MAIN FRAME(1). Place the RIGHT FOOT PEDAL
ASSEMBLY(46R) onto the right end of the PEDAL SHAFT(44) and place the LEFT FOOT PEDAL
ASSEMBLY(46L) onto the left end. Secure the FOOT PEDALS with BUTTON HEAD BOLTS
(M8x15mm)(94) and LARGE WASHERS(M8)(109) at both ends of the PEDAL SHAFT(44).
NOTE: You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x15mm)(94) at both
ends of the PEDAL SHAFT(44) at the same time.
R
R
L
