10
1.5.1.1
Using the “Stop / Reset” button
This button allows several actions to be performed on the product in correlation with the Error/Info LED.
Action
User action required
Error / Info LED status(es)
Block triggering
of alerts
(BLOCK mode activated)
Press the button for 2 seconds.
Off > continuous red.
Unblock triggering
of alerts
(BLOCK mode disabled)
Press the button again (after the previous
operation above) for 3 seconds.
Solid red > off.
Reset the product.
Press the button for 8 seconds.
Continuous red > flashing (after 8
seconds) > off (when the button
is released).
Reset to factory
configuration
(loss of configuration)
**
.
- Press for 8 seconds,
- Release the button when the Error/Info LED
starts flashing rapidly,
- Then press immediately until the same LED
flashes slowly,
- Then release the button permanently.
Off > continuous red (first press)
> rapid flashing (after 8 seconds)
> slow flashing (after releasing
and pressing again) > off (after
releasing).
* This action causes a warning SMS to be sent to the contacts programmed in the configuration.
* Returning to factory settings will return the unit's default PIN code: 1513.
The SIM card PIN code, on the other
hand, does not change
.
1.5.1.2
Behaviour of the LEDs
The behaviour of the LEDs can be interpreted as follows:
LED(s)
Colour
Behaviour
Error/Info
Red
- Off: Normal operation,
- Continuously lit: "BLOCK" mode activated,
the alarms cannot be triggered
,
- Flashes continuously: GSM connection error detected (PIN code,...),
- Lit for 3 seconds: receiving an SMS.
The behaviour of the LED during Reset/Return to factory configuration operations is
defined in section
1.5.1.1 Using the "Stop/Reset" button
.
GSM
Green
- Off: GSM deactivated,
- Continuously lit: GSM signal search,
- Flashes at 3-second intervals: valid GSM reception,
- Flashes every second: incoming call in progress.
32V IN4
32V IN5
Green
- Lit: input activated.
- Off: input not active.
OUT1
OUT2
OUT3
Orange
- Lit: output activated.
- Off: output inactive.
1.5.2.
General operation
The INCALL(1/2/3) functions linked to the OUT(1/2/3) relay outputs respectively allow the remote triggering of an
alert or event by an incoming call. To do this, the call must be made to the SIM card number in the GSM control from
a registered number with the appropriate rights to the product.
The ALARMSMS function uses the IN(4/5) alarm inputs and activates the sending of an SMS notification following
the triggering of an alarm or event to authorised numbers.
The SMSFORWARD function enables the transfer of SMS messages sent by the telephone operator on the GSM
control to authorised numbers. This function is dedicated to the administrator role.
The NEWS function allows anyone who knows the PIN code of the GSM control to send messages to it, which will
then be forwarded to all contacts with the assigned NEWS function.
EN
