Boca 112k DynamicDuo, Справочник по аппаратуре

Страница: 17 / 64

17 17
17 17
17
2.4 2.4
2.4 2.4
2.4 TTTTTesting the Connection esting the Connection
esting the Connection esting the Connection
esting the Connection
1. Install and start your communications software. Place it in
terminal mode and select the modem you wish to test. Refer to
the program’s documentation if you require assistance. If you
If you
If you If you
If you
are not in terminal mode, A are not in terminal mode, A
are not in terminal mode, A are not in terminal mode, A are not in terminal mode, AT commands typed in at the DOS
T commands typed in at the DOS
T commands typed in at the DOS T commands typed in at the DOS T commands typed in at the DOS
prompt will result in a “Bad Command or File Name” prompt will result in a “Bad Command or File Name”
prompt will result in a “Bad Command or File Name” prompt will result in a “Bad Command or File Name”
prompt will result in a “Bad Command or File Name”
message
message
message message message .
2. Type in A A
A A
ATZ TZ
TZ TZ
TZ followed by ENTER and the modem will respond
with OK after a few seconds. If the modem does not respond
OK, refer to
Troubleshooting (Section Three)
.
3. Type A A A A ATH1 TH1 TH1 TH1 TH1 followed by ENTER and you should hear a dial
tone from the modem speaker. To adjust speaker volume up,
refer to your communications software, or type the A
A A A ATL3 TL3 TL3 TL3 TL3
command the press ENTER.
4. Type A A A A ATH TH TH TH TH followed by ENTER to put the modem “on-hook”.
This confirms that the modem has been successfully installed
into the computer. Repeat steps 1-4 to test the Line 2 modem.
5. Your modem is now ready for use. Continue now with your
communications software and documentation.
Installation Installation
Installation Installation Installation
9346.p65 11/20/97, 9:33 AM 17