Manual 2100-583G
Page
9 of 48
MIS-3161
3/4" CONDUIT CONNECTION TO
INTERNAL CONTROL PANEL FOR
LINE POWER, AND FLOW CENTER
1/2" PLASTIC CONDUIT
CONNECTION TO LOW VOLTAGE
TERMINAL STRIP
WIRE ROUTING TO CONTROL PANEL
CENTER POWER
LIQUID-TITE CONDUIT FOR
POWER ENTRANCE & FLOW
ENTRANCE POINTS FOR 3/4"
ENTRANCE POINTS FOR 1/2"
PLASTIC CONDUIT FOR
CONTROL WIRING TO AQUA-STAT
FIGURE 2
WIRE ROUTING TO CONTROL PANEL
POWER & CONTROL WIRING
HIGH VOLTAGE LINE SUPPLY
Supplied with the unit is an adequate length of ¾" liquid-tite
conduit and fittings to run internally within the sheet metal
chassis from the control panel to one of four (4) 1⅛" holes
in the chassis sides (front/rear corners) for line voltage wires
to be ran through. See Figures 2 & 4.
LOW VOLTAGE CONTROL WIRES
Supplied with the unit is an adequate length of ½" plastic
conduit and fittings to run internally within the sheet metal
chassis from the low voltage box to one of four (4) ⅞" holes
in the chassis sides (front/rear corners) for thermostat wires
to be ran through. See Figures 2 & 4.