Blueworks BLSC, Инструкция по установке и эксплуатации

Страница: 10 / 32

9
Install cell:
Install using the unions provided. Tighten by HAND for a watertight seal. For pool/spa
combination systems with spillover, refer to the above Overview to allow chlorination for
both the pool and spa during spillover but preventing over chlorination when operating the
spa only. For proper plumbing, refer to the overview diagram on page 4. NOTE: The
following are basic plumbing instructions for the typical installation, which entail
positioning the Flow Switch and Cell adjacent to each other on 2" plumbing. Your
installation may vary depending on space available and your specific arrangement of
equipment. IMPORTANT: Ensure that the pool pump and all AC power is turned off before
installation.
Flow switch :
IMPORTANT: To insure proper operation, verify that the arrow on the flow switch (located
on the side) points in the same direction of water flow.
The Flow Switch and Cell are to be fitted into the return line as the last pieces of
equipment the water passes through before returning to the pool: always after the pump,
filter, heater (if applicable), etc. If a heater is present, all equipment must be a minimum
distance away, per heater manufacturer recommendations.
Lay out your equipment to ensure there is enough pipe space available.

When positioning the Flow Switch, ensure at least 6 to 12
”
(30cm) of straight pipe
before the Flow Switch. If installed after the Electrolytic Cell, the Cell provides this
space. The raised arrow on the black plastic cap must be pointed with the direction
of water flow as it returns to the pool. If installed horizontally, ensure that the
wire-side faces upwards. The Flow Switch is approximately 4" in length; the typical
gap required is 1
¼
".

When positioning the Cell, you can consider the side of the cell with the cord the