BlueLine HAZINATOR, Руководство по эксплуатации и обслуживанию

Страница: 27 / 48

SECTION 4
WATER PUMP DRIVE BELT
To tighten the water pump belt:
1. Loosen the four nuts, which hold the water
pump base to the frame.
2. Adjust the position of the belt tensioning
adjusting bolt until the proper belt tension is
achieved. (3/4” deflection in the center of the belts,
half way between the pulleys).
3. While checking the alignment, tighten the nuts
that hold the water pump to the base.
FLOAT VALVE (WATER POND
®
)
1. If the water pond
®
is overflowing, remove and
check the float valve for damage, or debris.
PRESSURE REGULATOR
The pressure regulator holds water pressure at a
preset point and bypasses this water back to the
water box.
To adjust:
1. With the unit running, close the cleaning tool
valve. Check the pressure gauge. Open the tool
valve. Set the pressure regulator so that the
pressure gauge reads 350 PSI with the tool valve
open.
With the tool valve open, there should be a normal
drop of approximately 100-PSI, in pressure.
If the
drop is greater than 100 PSI, it may be
necessary to lubricate the pressure regulator o-
rings.
2. To adjust the pressure regulator, turn the
adjusting knob (while observing the pressure gauge
on the control panel) until you reach the desired
pressure.
BLUELINE HAZINATOR
®
22