U
SER
M
ANUAL
WRAP
P
RODUCT
S
ERIES
Figure 2. WRAP 2151 Starter Kit Management Port Connector Location.
The serial port settings for the management console are shown in Table 1. When you use the management
console, you are automatically logged in as the superuser (root). The serial cable is in fact a standard direct
cable for WRAP 1260 and WRAP 3000 products and a standard cross-over cable for WRAP 2151 Starter
Kit.
Setting
Value
Speed
115 200 bps
Data Bits
8
Parity None
Stop Bits
1
Flow Control
None
Table 1. The Management Console Port Settings.
2.2 A
CCESSING WITH
T
ELNET
When the WRAP is connected to a LAN, you can also use a telnet client to connect to the board (to the
standard telnet port, 23) and perform the same functions remotely as you would locally from the
management console. To see the IP address of the WRAP board, connect to the WRAP with a management
console, power on the board and after the system is up and running, give the command "ifconfig". The field
"inet addr" for the interface "eth0" contains the IP address of the WRAP board. For example, in the
following capture from the management console, the IP address is "10.1.1.32":
8 (26)
