Bluegiga Technologies WRAP 1260, Руководство пользователя

Страница: 10 / 26

U
SER
M
ANUAL
WRAP P
RODUCT
S
ERIES
3 C
ONFIGURATION
When the WRAP is installed and powered up for the first time, the default configuration settings are being
used. With these settings, the WRAP automatically configures its network settings assuming that the board is
connected to a LAN network with a DHCP server running. After booting, you can use the WRAP as a
Bluetooth LAN access point to the network without any changes in configuration. Also the Serial Port
Profile is enabled by default in listening mode.
3.1 U
SING THE
S
ETUP
A
PPLICATION
The basic configuration settings are changed using the "setup" application. It displays the settings in a
hierarchical menu. Navigating the menu is accomplished by entering the number or the letter of the setting to
view and/or change and pressing <enter>. Pressing only <enter> either accepts the previous value of the
setting or returns to the previous level in the menu hierarchy. The settings and their meanings, and the
default values are described in the following sections.
3.2 N
ETWORK
C
ONFIGURATION
Note: this setting is not applicable for WRAP 1x60.
1. Enable Interface Eth0 [Y]
This option determines whether or not an Ethernet interface is brought up at all at boot. If set to no, the
other options in the Network Configuration menu are not visible.
2. Use Dynamic network configuration [Y]
This option determines whether or not automatic configuration of the Ethernet interface using DHCP
should be attempted at boot. If set to yes, the following options in the Network Configuration menu are
not visible.
3. IP address of the host [10.0.0.101]
If the dynamic network configuration is disabled (step 2), the IP address of the WRAP must be entered
here.
4. Subnet mask [255.255.255.0]
If the dynamic network configuration is disabled (step 2), the network mask of the WRAP must be
entered here.
5. IP address of the default gateway [10.0.0.254]
If the dynamic network configuration is disabled (step 2), the IP address of the default gateway in the
LAN to which the WRAP is connected must be entered here.
6. Hostname of the device [wrap]
The hostname of the WRAP device. Local applications will see this name.
7. Domain of the device [local.net]
The domain name of the WRAP device. Local applications will see this name.
8. IP address of the primary name server [10.0.0.1]
The IP address of the primary name server.
9. IP address of the secondary name server [10.0.0.2]
The IP address of the secondary name server.
3.3 B
LUETOOTH
S
ETTINGS
Bluetooth settings are divided into general and profile specific settings, which are described in the following
sections.
10 (26)