Bluegiga Technologies WRAP 1260, Руководство пользователя

Страница: 24 / 26

U
SER
M
ANUAL
WRAP P
RODUCT
S
ERIES
4.6.1 S
YSTEM
R
EQUIREMENTS
The following hardware and software is required to re-install WRAP:
•
PC with
•
Serial port (D9 connector)
•
CD-ROM drive
•
Operating System
o
Windows 2000 or
o
Linux (tested with RedHat 6.2, 7.0, 7.1, 7.2 and 7.3)
4.6.2 R
E
-I
NSTALLING
WRAP
USING
M
ICROSOFT
W
INDOWS
To re-install WRAP under Windows:
1. Insert the WRAP CD into the CD-ROM drive.
2. Enter the root of the CD and double click reinstall.exe.
3. Make sure that the WRAP board is connected to the PC via the management serial cable (see section
2.1 for details of connectors), and that the power cable is disconnected.
4. (Optional) If you use a serial port other than the default COM1, you can change it from the Settings
menu.
5. Click the Install WRAP button.
6. When asked to do so, turn on the WRAP board by connecting the power cable.
7. Wait for a couple of minutes until the software has completed the installation process. (A message
will be displayed.)
8. Close the installation software by clicking Exit button.
9. (Optional) Start a terminal emulator (the serial port settings for the console are 115200bps, 8 data
bits, no parity, one stop bit) if you want to see the system boot-up procedures.
10. Restart the WRAP board: either press the reset button on the board (see the corresponding hardware
manual), or disconnect the power cable, wait for 10 seconds, and reconnect the power cable. Note: at
least some laptops require that also the management console cable is disconnected before restarting.
4.6.3 R
E
-I
NSTALLING
WRAP
USING
L
INUX
To re-install WRAP under linux, mount the WRAP CD, change the current working directory to where it is
mounted, run reinstall-script as root, and follow the instructions. The management serial cable must be
connected and, when asked, the power cable needs to be connected too. See section 2.1 for details of
connectors.
Example (things you need to type are in written
like this
):
$ su -
$ mount /dev/cdrom /mnt/cdrom
$ cd /mnt/cdrom
$ ./reinstall
(or 'sh reinstall' if you get access denied error)
After installing the boot loader and the operating system to the WRAP board, you may boot your WRAP
hardware (press the reset button or disconnect and reconnect the power cable) and begin using it.
24 (26)