U
SER
M
ANUAL
WRAP
P
RODUCT
S
ERIES
2 Q
UICK
S
TART
The WRAP boards are delivered with the latest release of the WRAP platform installed. No additional
installation is required for getting started with the WRAP. Just connect the Ethernet cable (WRAP 2151 and
3000 only) and the power cable and the WRAP boots up. After this, you can connect to the WRAP using a
device that has Bluetooth LAN Access Client profile support. The WRAP board can be seen in Bluetooth
inquiries called as "BlueGiga_xxx", where xxx will be the last three digits of the product serial number. If
you cannot use Bluetooth to connect to WRAP, read further.
2.1 M
ANAGEMENT
C
ONSOLE
The simplest way to configure, monitor, and control the WRAP board is to do it from a management console.
By "management console" we mean any PC running terminal emulation software (such as HyperTerminal in
Windows or minicom in Linux) connected with the serial cable shipped with the product to the management
port of the WRAP board. The location of the management port in WRAP 1260 and WRAP 3000 is shown in
Figure 1 and in WRAP 2151 Starter Kit in Figure 2.
Figure 1. WRAP 1260 and WRAP 3000 Management Port Connector Location.
7 (26)
